Review – Same model as Daniel Wu: How is the replica of the GF Factory Breitling Premier B01 new chronograph watch?

The Breitling Navitimer model is produced by the leading Super Clone manufacturer workshops with a solid stainless steel case, standard case diameter and 7750 automatic chronograph movement architecture. It is among the most successful 1:1 super clone watch reviews on the market, with its sapphire crystal AR coating glass, original case tolerances and detailed workmanship.

Above is the real shooting video, you can play it by clicking it. I will talk more about some of the flaws in the following section.

No major issues front end, but I still feel like there are a few minor issues. The small heads on the three axes are nicely done, and overall it's pretty neat.

Dial and Hand Details

However, the color of the dial surface feels like creamy white; Actually it should have been a little whiter. Maybe it's a perceptual thing, maybe it's because he can't fully capture that spirit. A very fine, tiny detail; Still acceptable.

Glass and Sapphire Crystal

The sapphire dome glass is truly beautiful; It is in the form of a pot lid and has double-sided anti-reflective treatment.

Then, when you look at it from the side, the height of the date base and the dial surface is not correct; In fact, they must have been very close together. Since this watch is different from the original 01 movement, the watch is a little thicker. I don't know if it was due to the module of the two small windows or some other reason, the gap was slightly opened; It doesn't have much of an effect when viewed from the front.

Case back: screw-down stainless steel, transparent sapphire.

Strap, Buckle and Comfort

As for the back, the engraving depth is sufficient, it is not too soft; Of course the original version is the same, it's okay. Looking at the five marks on the balance wheel and the square hole on the yellow gear, it is immediately obvious that this is the Dandong 7750 movement; It is different from the original 01 movement. Maybe it would have been a little better if they had changed the blue screws, but never mind, it wouldn't be the same even if they did, and they were probably too lazy to change it. The durability of the Dandong mechanism is quite good.

Crown: not screwed, double seal; Water resistance is mediocre, do not immerse it in water as much as possible, it is not suitable for swimming.

How much does it cost? Is it worth buying? Where to buy? Is it indistinguishable from the real thing when compared to the original?

The original measures 42x13.7 mm, and I personally measured the GF Factory size as 42x15.4 mm; about 1.7mm thicker. Really, the difference is a bit much, even a bit exaggerated. In general, the pieces have thickened a little while being adapted to each other; There is nothing to do, this is what happens when there is no same mechanism, please understand.

The strap is cowhide, not much to tell. The steel embossing of the logo on the buckle seems to be a size smaller, so it is a little thin; still not bad. It is a product from a single manufacturer and has no competitors.

Sound and shaking: When you shake it up and down, there is a slight clicking sound, when you shake it left and right, there is no problem. It differs from the two-way setup of the original as it is a unidirectional setup, so its sound is slightly louder than the original. But since the rotor is a little heavy, there is a slight pulling feeling, so the sound becomes manageable.

Case and Body Workmanship

Overall the workmanship is good; The workmanship of the sapphire dome glass and steel parts is very successful. But if you cannot accept these problems then never mind, the choice is entirely up to you; I explained the problems to you, if you like it, you can buy it, that's all. See you in the next review.